⚠️ Beta clinical support software. For licensed healthcare professionals only. AI outputs may be inaccurate and depend on third-party LLM capabilities. Mandatory physician verification is required before any clinical decision.

🔬 Lab Devices (USB)

Connect your device, capture data, and send it to AI analysis in one place.

📈 ECG

Live waveform capture from ECG device

🫁 Spirometry

Pulmonary function metrics and flow-volume curve

📷 Ultrasound / Endoscopy

Frame capture from camera or capture card

What is happening now

Selected section: ECG.
Auto-open on new study: enabled.
Last received study: none yet.

Adapter status

ECG USB

Idle

Browser

Spirometry USB

Idle

Browser

Camera capture

Idle

Browser

X-ray hot-folder

Idle

Hot-folder

CT hot-folder

Idle

Hot-folder

MRI hot-folder

Idle

Hot-folder

Data flow

From device to ready-to-analyze study

• 1) Data is captured on the device

• 2) Data arrives into Device Hub

• 3) Study is routed to the target module draft

• 4) Study is ready for AI analysis

Start in 3 steps

Step by step

Connect your device (or camera) to the computer.
Open this page in Google Chrome.
Allow device access and press Connect in the selected tab.

🔌

Auto-ingest for X-ray / CT / MRI

New studies can be routed into the correct module automatically.

Mode

Automatically open the target module when a new study arrives

Check if ingest is working

Real hardware check

Quick checklist before field use

Open this page in Google Chrome on the target workstation.
Connect the real device/capture card and confirm it appears in the source list.
Run one real capture and confirm result appears in the selected module.
For radiology, send one real study to hot-folder and confirm auto-routing.
Open the target module and run analysis to verify full end-to-end flow.